A Netgear WiFi router can work in three basic modes, namely Router Mode, AP Mode, and Bridge Mode. The functions of all these three modes differ from one another. When set up in the Router Mode, the Netgear router will work as a router by connecting the WAN network of your modem. Talking about the Bridge Mode, the router functions as a bridge between the existing router and modem.
Regarding the AP Mode, the router acts as an access point. This means, it takes data from the modem through an Ethernet connection and then converts it to two frequency bands, i.e. 2.4 GHz and 5 GHz. The WiFi-compatible devices near the network are able to send and receive wireless traffic from the access point. Furthermore, the Access Point Mode is also known to widen the WiFi coverage of your house or workplace.
Know More About Access Point Mode
No matter which mode you want to use, you can always access routerlogin.net web-based page to set up your Netgear router. The AP mode is much better than utilizing a WiFi range extender as the extender cuts down on the frequency capacity of your Netgear WiFi network. However, when the router works as an access point, it multiplies the bandwidth capacity.
One of the basic functionalities of the Netgear router in the AP mode is that it acts as the wireless gateway. Let us tell you that the Netgear WiFi router, when working as an access point, loses the entire functions of a router which includes DHCP server connection, port forwarding, and much more. It will only act as an access point.
Without further ado, let’s get to know how to install Netgear router in the Access Point Mode.
Steps to Set up Netgear Router in the Access Point Mode
Below-given are the instructions to install your Netgear WiFi router in the AP mode:
-
Connect your AP router to the current main router via an Ethernet cable.
-
Access the routerlogin web interface of your AP router using a PC.
-
Type the user ID and password into the given fields.
-
Hit Log In.
-
Wait until the Netgear genie detects the other existing router on your network.
-
As soon as the main router is detected, choose the Yes option and then hit the Next button.
-
In the event that you wish to set a static IP on the access point, choose the option that says ‘Use Fixed IP Address’.
-
The AP router reboots on its own.
-
Now, you will be taken back to the screen that shows the main router’s wireless settings.
-
After you get connected successfully, you will see a web page telling you that the setup is successful and the AP router is now online.
-
On the off chance if you again access the Netgear router login web interface, you will find that it is functioning as an Access Point.
Done! You have successfully set up your Netgear wireless router in the Access Point Mode. In case of any difficulty, reach out to our experts.